Compatible Systems MicroRouter 900i Manuel d'utilisateur télécharger pdf (Page 56)

56 - Maintenance - Section 7 Microrouter CNC Machine User's Manual

7: Lubrication of Sliderails

Z Axis Sliderail Lubrication.

The Z axis has two sliderails, fitted between the upper and lower

slideframe assemblies. The sliderails are located either side of the

leadscrew, running parallel with the leadscrew in the same plane.

Run the machine head up fully, to gain access to the bottom end of the

sliderails. Spray lubrication directly onto the exposed surface of the

sliderails.

Run the machine head down fully, to gain access to the opposite

end of the sliderails. Spray lubrication directly onto the remaining

surface of the sliderails.

Finally, run the machine head up and down along the Z axis, to

distribute lubrication along the full length of the sliderails.

Lubricate

along the left

(A) and right

(B) sliderails

(arrowed).

Location

Look between upper

and lower slideframe

assemblies.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 93 94

Pas de commentaire

Compatible Systems MicroRouter 900i Manuel d'utilisateur Page 56