Compatible Systems MicroRouter 900i Manuel d'utilisateur télécharger pdf (Page 41)

Section 6 - Work Holding - 41Microrouter CNC Machine User's Manual

6: Assembling the Work Holding Clamp Rails

To assemble each clamp rail:

1) Place the long, deep, U shaped section upside down, on a flat

workbench, so the bottom of its channel is facing upwards. Place

the shorter, shallow, U shaped section on top, so the bottom of its

channel is facing down. Position this U shaped section so the

single holes at each end align with the inner thread holes of the

lower U shaped section.

2) Insert the long part threaded M8 allen headed bolts through the

two holes in the upper U shaped section and carefully fit them

into the matching threaded holes in the lower U shaped section.

3) Carefully fit the short M8 allen headed bolts into the remaining

threaded holes, one at each end of the lower U shaped section.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 93 94

Pas de commentaire

Compatible Systems MicroRouter 900i Manuel d'utilisateur Page 41