Compatible-systems 5.4 Manuel d'utilisateur télécharger pdf (Page 93)

Chapter 4 - AppleTalk Routing & Bridging 87

connected to this interface, for Phase 2. Acceptable values vary from 1 to

65,279. The value on the left must be smaller than the value on the right.

Each individual number in the range will support up to 253 node addresses.

v Note: Accidental selection of an AppleTalk network number (or range of

numbers) which is already in use on another network segment may cause

hard-to-diagnose problems. You should carefully track which AppleTalk

network numbers are in use, and where they are used.

Phase 2 Zones

For an AppleTalk Phase 2 Bridge Group which you set to Seed Phase 2, you

must provide a network number range. These are the names associated with

the network number range entered above. You must specify at least one name,

but it isn’t necessary to specify a name for every number in the range. Zone

names may be up to 32 characters in length.

Typically names are chosen which have some significance to the physical

location or the corporate purpose of the network segment(s). Examples would

be “Main Accounting,” “Cost Accounting” and “Bookkeeping.”

These names will appear in the Chooser program of computers which support

AppleTalk. using the Network Control Panel, Macintosh computers are able

to pick the zone in which they are located.

Phase 2 Default Zone

Use the Default button next to the Zone list to select which entry the router

should designate as the default zone name for the segment(s) which are part

of the group. If you do not specify a default name, the router will designate

the first name in the list.

Phase 2 Node

You can provide a suggestion for the node number the router should use on

this AppleTalk Phase 2 Bridge Group.

v Note: The AppleTalk protocol allows network nodes to dynamically claim

node numbers when they start up. Assigning known AppleTalk node numbers

to router interfaces can make it easier to diagnose network problems using a

network packet monitor.

NBP Lookup Filters (Filtering)

The parameters required for NBP Filtering are contained in a configuration

screen brought up by the “Filtering” button. This screen is discussed later in

this chapter.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 312 313

Pas de commentaire

Compatible-systems 5.4 Manuel d'utilisateur Page 93