Compatible-systems 5.4 Manuel d'utilisateur télécharger pdf (Page 123)

Chapter 7 - VPN Client Tunnels 117

> Allow Connections To

This scrolling list displays the IP networks which the client will be told are

reachable via the tunnel.

Any communications with an address which is part of one of the networks in

the list will be tunneled. Communications with any other addresses will occur

normally, without tunneling.

> Add

Clicking on this button will bring up a dialog box which allows an IP network

address and mask size to be entered.

Add IP Address Dialog Box

The part of this address which identifies the network segment is determined

by the size of the mask, specified in bits. For example, an entry of

192.168.32.0/19 would specify that traffic with all IP addresses from

192.168.32.1 through 192.168.63.255 will be tunneled. As a special case, the

entry, 0.0.0.0/0, specifies that all IP traffic should be tunneled. To tunnel to

only a single host, specify 32 in the bits portion.

v Note: Following convention, mask values in CompatiView are generally

entered as decimal numbers separated by periods (e.g. 255.255.255.0) where

both the network portion and the host portion of an address are significant.

Entry of mask size in bits is an alternative but equivalent way of specifying

the size of the network portion of the IP address when only that portion is

significant to the function being performed.

Edit

Clicking on this button brings up a dialog box which allows editing of a previ-

ously entered network and mask.

Remove

This button removes a network/mask entry from the list.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 312 313

Pas de commentaire

Compatible-systems 5.4 Manuel d'utilisateur Page 123