Compatible Systems MicroRouter 900i Guide d'installation télécharger pdf (Page 14)

Chapter 2 - Quickstart Configuration 10

TB: Use configure and set the Numbered and Net keywords in the IPX WAN 0 section.

Suggested for IPX

The settings above are all that is generally required for IPX operation over Frame Relay.

AppleTalk Protocol

Required for AppleTalk

Frame Relay operation requires that the WAN interface be set as a “numbered interface.” This

means that the interface (and thus the Frame Relay network) must have an AppleTalk network

number and the interface must have an AppleTalk node number.

• AppleTalk numbered interface

• AppleTalk network number

• AppleTalk node number

• AppleTalk zone name

CV: Use the AppleTalk Routing: WAN Dialog Box.

TB: Use configure and set the Numbered, NetLower, and DefZone keywords in the Apple-

Talk WAN 0 section.

Suggested for AppleTalk

The settings above are all that is generally required for AppleTalk operation over Frame Relay.

DECnet Protocol

Required for DECnet

In order to be used, DECnet must be turned on both globally and for a particular port.

WAN interfaces which are set for Frame Relay operation do not need any additional parame-

ters set in order to function.

• Set DECnet on (globally, and for this port)

CV: Use the DECnet Routing Dialog Box (under Global/DECnet Routing) and the DECnet:

WAN Dialog Box.

TB: Use configure and set the Mode keyword in the DECnet WAN 0 section.

Note: Setting DECnet on for any port with the command line also sets DECnet on globally.

In CompatiView you must set a global parameter and a port-specific parameter.

1 2 ... 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Compatible Systems MicroRouter 900i Guide d'installation Page 14