Compatible-systems MicroRouter 2220R Manuel d'utilisateur télécharger pdf (Page 32)

26 Chapter 6 - Basic Configuration Guide

DECnet Protocol

Required for DECnet

The router’s shipping configuration does not have DECnet turned on.

In order to be used, DECnet must be turned on both globally and for a

particular port.

WAN interfaces which are set for PPP dial-on-demand operation should

have their DECnet hello timers and DECnet routing timers set for a

fairly long period, since the link will be brought up when this informa-

tion is transmitted.

Because of the need to regularly bring the link up to exchange routing

information, on-demand operation using DECnet is not recommended.

• Set DECnet on (globally, and for this port)

• Set DECnet area

• Set DECnet node

• Set hello timer

• Set routing timer

CV: Use the DECnet Routing Dialog Box (under Global/DECnet

Routing) and the DECnet: WAN Dialog Box.

TB: Use configure and set the HelloTimer and Mode keywords in

the DECnet WAN 0 (and/or WAN 1) section. Use configure and

set the Enabled, Area,andNode keywords in the DECnet

Global section.

Note: Setting DECnet on for any port with the command line also

sets DECnet on globally. In CompatiView you must set a global

parameter and a port-specific parameter.

Suggested for DECnet

Setting the parameters above should be adequate for most installations.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 48 49

Pas de commentaire

Compatible-systems MicroRouter 2220R Manuel d'utilisateur Page 32