Compatible-systems 10/100 Manuel d'utilisateur télécharger pdf (Page 6)

Chapter 1 - Network Installation 3

Connecting a Management Console

To connect a management console, use the supplied cable and connect to the Console interface

on the 10-100 Ethernet - DES I/O card. You can use a dumb terminal or a computer equipped

with VT100 terminal emulation.

The default settings for the Console interface are VT100 terminal emulation, 9600 bps, 8 bits,

no parity, 1 stop bit and no Flow Control.

v Note: The 10-100 Ethernet - DES I/O card also has an AUX interface. This is a modem

connection which should only be used in consultation with Compatible Systems Technical

Support staff, who will provide instruction on its use.

v Note: If you want to use Telnet as a management method, you must first configure an IP

address into the server using an out-of-band console, or reconfigure the IP address on an IP

host or workstation on the same Ethernet segment as the server. See Chapter 4 - Command

Line Preparation in the IntraPort Carrier Chassis section of the manual for more information.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Compatible-systems 10/100 Manuel d'utilisateur Page 6